High frequency. With display. Wide range of accessories, such as temperature controlled charge and “Easy Pick” battery selector. • 15935 Answers SOURCE: 'F05' is an indication of a water temperature sensor (NTC) error, or Heating Circuit failure. Check the Water Temperature Sensor and check connections to the Water Temperature Sensor. To access, you will have to UNPLUG your washer and remove the lower access panel under the door. The panel comes off by removing the screws under the bottom edge. HINT: If you place a block of wood under each front foot of the washer, it will make access to the screws much easier. If the panel sticks, a tap on the sides will knock it free. The panel will drop down then come off. The sensor (NTC) is located at the base of the wash tub in the front on the heating element. This will be a small square shaped plug between the heating element terminals. Unplug the wire harness and take a resistance check. Readings will be as follows: Temperature Meter Reading 32°F (0°C) 35.9 K ohms 86°F (30°C) 9.7 K ohms 104°F (40°C) 6.6 K ohms 122°F (50°C) 4.6 K ohms 140°F (60°C) 3.2 K ohms 158°F (70°C) 2.3 K ohms 203°F (95°C) 1 K ohms Roughly.around 9K ohms at room temperature if I'm reading the chart correctly. Take readings as listed and also double check the connector to make sure it is not oxidized. Try cleaning the plug and reconnecting to see if the error code goes away. Evil ken sf2 download. Fight night champion game save editor ps3. If not, you will probably have to replace the sensor. ![]() If the sensor checks good, take a reading across the heating element terminals. It should indicate about 15 ohms. Best dos emulator windows 10. Lastly, remove the washer top panel by removing the three screws holding the panel in place in the rear. Once the screws are removed, slide the panel back then off. Locate the Central Control Unit (CCU) directly behind the wash tub. ![]() Take a resistance check at the Heating Element Solenoid by removing connector 9 from the CCU (this is the second connector from the RIGHT as facing from the front). A reading across test points 1 & 2 should also read 15 ohms Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question.!!!! Posted on Sep 29, 2010.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |